This command will perform the wildcardĮxpansion and return a Tcl list. If you want to use wildcards when importing files, you will have to use The place were theįiles will be added in the MSX directory structure is selected Multiple files andĭirectories can be specified at the same time. In case of a it will import the files and subdirectories in This will import the single into the disk These are the commands understood by the diskmanipulator: The diskmanipulator and all its commands (including most parameters) can be tab completed in the console. depend upon the command involved, see the detailed descriptions of the commands below.

For example hda2 is the second partition on the master IDE disk, hdb3 is the third partition on the slave IDE disk. In case the disk contains a Sunrise IDE (or Beer IDE 1.9RC1) compatible partition table (FAT12 only!) you can add a partition number (from 1 till 31) to the disk name to specify on which partition the command will act. This allows interaction with the currently used disk images. disk and hd are the drives available to the running emulated MSX machine. Typical values are: diska, diskb, hda or the special virtual_drive device. The next section lists the commands available and explains them.

The general command syntax is always of the form: Or manipulate files on hard disks formatted for use with a SCSI interface So, you cannot create valid formatted SCSI hard disk images, SD card images

Note: For now, this command does not work with SCSI/SD disks and drives!

Blank floppy disk image creator